To test bandwidth between FortiGate's port1 and iPerf3 server (the main IPerf3 server resolves to 45.154.168.155 and listens on port 5200-5209), follow these FortiGate is acting as an iPerf3 client in this scenario. Iperf server can be public or setup a private one. TCP/UDP traffic test against an iPerf server.In multi-VDOM environment, run the test at the global level. Thus, it will not provide the actual bandwidth metrics. The test between ports, as shown above, will test only the basic function of the interface and it does not send any actual traffic/data between them. It can be used only for the interface tests between FortiGate ports or as a client towards a server. The iPerf3 server on the FortiGate cannot be used as a full-featured iPerf3 server. Iperf3: interrupt - the server has terminated It can also be used between two ports that are in two different VDOMs and verify the connectivity at the hardware level.ĭiag traffictest server-intf port2 <- Define a FortiGate interface.ĭiag traffictest client-intf port1 <- Define a FortiGate interface.Ĭonnecting to host 10.109.19.237, port 162 It is used to determine whether transmitted signals return to the sender. Perform loopback testing between two different FortiGate ports:Ī loopback test is a simple method to determine whether the communication of circuits is functioning at a basic interface level.The FortiGate firewall has a built-in iPerf3 client and a limited embedded iPerf3 server. Publicly available iPerf/iPerf3 Servers.This article describes how to use the diag traffictest command for the following purposes:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |